News Letters
Home > Bathroom > How to unclog bathroom sink?

How to unclog bathroom sink?

By Farrukh Jhanzaib
Share with your network

Bathroom sinks can become clogged with hair, soap suds, floss, and other sanitary chemicals, making them practically impassible. But, before you hire a plumber, there are several different techniques of cleaning that are exceedingly simple and, best of all, economical. Here  you can read some effective ways to Unclog  bathroom sink.

What causes blockages in sinks?

Your hair:

Excessive shedding of hair in the bathroom sink might damage the drain.

Oil from the dishes:

Oil build up on bathroom sink surfaces can cause blocked drainage.

Toiletries:

Items such as cotton swabs, dental floss, and paper towels should not be placed in the drain. Because they create a solid blockade.

Soap and soap scum:

If your bathroom sink is clogged, it’s likely that your soap is the problem. Liquid bath soaps produce foam that flows down the drain and eventually build up in pipes, causing blockages in no time! A complete guide how to Unclog your bathroom sink

Obstruction deeper in the line:

Sometimes, the stuff goes deeper into the sewer lines and make a clog there. In this case a simple remedy may not be possible.

Damaged pipes:

If your bathroom sink drains slowly or not at all, it may be due to a damaged pipe or pipes. 

What tools should I use for clearing my bathroom sink drain?

To clear your bathroom sink drain, you only need a few essential items:

1. Use a drain snake.
2. Plunger.
3. Bucket and sponge.
4. Trash can with lid.
5. Gloves and safety eyewear.
6. Bring rags and towels.

Use Zip It hair removing Tool:

unclog bathroom sink

An easy way to unclog your bathroom sink drain is to insert a flexible, flat, thin plastic strip with a series of teeth called a “Zip-It.” Rock the tool back and forth to dislodge any debris or hair that may have gotten lodged in your pipes, then carefully pull it out.

Hair clumps are the reason behind 90% of clogged bathroom sink drains. If so, you shouldn’t even need to proceed with the following few steps because a “Zip-It” drain clearing technology should take care of the problem!

Use warm water in the sink drain:

unclog bathroom sinkNext, pour boiling hot water down the sink drain. This should be enough to melt through anything in your drain and remove any obstructions.


To achieve this, just bring a pot of water to a boil over the stove. Once it has boiled, carefully pour the hot, boiling liquid down the sink drain, being cautious not to contact it with your hands! 

If the lack of handles or sidewalls on your bathroom sink prevents you from getting close enough, consider using a turkey baster in its place. This ought to clear most drains immediately. If you don’t see results right away after adding hot water, wait a little before trying again.

Look into using baking soda and vinegar:

The next step is to try unclogging the drain using vinegar and baking soda if hot water wasn’t able to solve the issue. Here’s how to unclog your sink quickly thanks to the chemical reaction that occurs when vinegar and baking soda are added: In the drain, pour about a half-cup of baking soda.

Add enough vinegar to the baking soda so that it begins to bubble up around the drain’s edges. Give it a few minutes to sit; if at all possible leave it overnight for the best results! After letting your solution settle, try it again if necessary.

Try out to plunge the clogged drain:

Plungers are useful for things other than toilets, did you know that? Clogs in your bathroom sink can be unclogged using a plunger! Just cover the top of your drain opening with the rubber portion of the plunger to do this. With both hands, forcefully press down; then, draw back up to suction obstacles upward. If necessary, wait a little before repeating, and take care not to push down too forcefully as this could break pipes if they are old enough!

Remove the P-trap of sink and clean it:

The curved pipe section under your sink is called a P-trap. Remove the P-trap, if you can, and clear out any hair or debris that may have become caught inside over time!


In order to do this, just twist the plastic nut on either side of the bathroom sink drain to separate the two sections. After removal, wash your pipes with hot water and soap, being sure to reach all the filth, especially inside the bend underneath. Use a small pail to collect the dirty water.
However, don’t put your P-trap back together right away. 

Clean your drain with a plumber snake:

In order to clear any obstructed debris inside your drain, you thread a long metal spiral instrument down the drain called a drain snake, sometimes known as a plumber’s auger. The snake has a hand crank on one side that is used to drill through blockage, while the other side is designed like a corkscrew. If none of the other options have worked, this is an excellent alternative!


Now that your P-trap has been removed from the wall, carefully put your drain snake into the wall pipe where your P-trap was previously attached. To advance the drill and, ideally, clear out any junk inside, turn the crank.
Reattach your P-trap now, and see if the situation has improved. It probably will.

Final thoughts:

Quickhomeexperts is always ready to help you out in troubling plumbing situations. Having a clogged sink is a real pain. Water doesn’t pass through sewer lines and seep through draining pipes. Therefore, this article better guides you about all the procedure to unclog bathroom sink.


Share with your network
About the author

Alden Dale has been remodeling homes since 2016 and has been writing for Quick Home Experts. Before joining Quick Home Experts, Alden provided home improvement advice for different readers and did it yourselfers for over 4 years. Alden earned a BA in Environmental Studies from the University of California and an MA in Environmental Research from Stanford University.

Leave a Comment